There are times when you wish to change the ladder reference style after a project is nearing completion. Changing the ladder reference could potentially affect the wire numbers, source and destination arrows, components and their cross references. Follow these steps to easily change an entire project to any of the available ladder reference styles.
Updating each drawings format
First of all we need to update the Project Properties to the new reference type. Right click on the active project and choose Properties from the menu. Switch to the Drawing Format tab and press the setup button in the Format Referencing area. Change to the desired type and press OK.
Also be sure to add %S to the other areas of the Properties dialog as well.
Now to push this change to the rest of the drawings. Select the first drawing in project and then while holding Shift select the last drawing. All drawing should now be selected. Right click on any one of them and choose Project and then Apply Project Defaults. (Alternately you could select one at a time and choose Settings compare from the same menu. This would allow a more controlled push of any changes in the Drawing Properties.)
Swapping the Ladder Reference Block
In this example we are switching from "Numbers Only" to "Sheet and Numbers." Each style has its own unique block. Each style type is shown below.
Start the Swap/Update Block command. Choose Project Wide and Pick new block from icon menu and then press OK.
Select the first number on any ladder in the project.
Press Do All and then OK in the Select Drawings dialog.
So now all ladders should have the desired Master Ladder Reference block.
On to a Project Wide Update and Retag. In the example each sheets first rung must start with 01.
Because each sheet will need to start over at 01 all sheets will need to be updated one sheet at a time. Select the first sheet and then choose Process. After the scripts are completed start the command again and verify the steps above are still in place. Choose the next drawing and continue working through the sheets one a time.
Running the sheets one at a time may have left the ladders all starting as if each is sheet one. Don’t worry this is easily fixed.
Rerun Project Wide Update and Retag once all sheets are completed. Choose Sheet and Resequence then process all drawings.
End this process by renumbering the wires and updating the components tags. All of which could be done again through the Project Wide Update and Retag command.