Deformed holes and constraints - IMAGINiT Manufacturing Solutions Blog

« Vault Updates | Main | Inventor Progress Bar »



Feed You can follow this conversation by subscribing to the comment feed for this post.


Where do I find the command: Surface patch ?

Rgs, Leif

Thanks for the question! You have to switch from the sheet metal environment to the 3D Model environment. Once you do, it is located on the Surface panel of the 3D Model ribbon tab.

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)