Okay, so it is more like 17 minutes. But I have compiled my four part Inventor tip series from Autodesk University into one video. These tips were presented right on the show floor but instead of just a video, the lucky viewers in the audience were graced with my presence. I even hung around to sign autographs after the presentation and hand out flash drives and other trade show swag. Okay, the only one who wanted my autograph was the person at the booth checking me off the list of other presenters showcased at the Authorized Training Center booth. Now, without any further ramblings...enjoy.
20 Inventor Tips in 20 Minutes - Autodesk University from Mark Flayler on Vimeo.
Links to previous posts (no audio, but descriptions of each tip)
How to download this video?
Thanks
Posted by: WANG JIANWU | 01/30/2010 at 02:04 AM
Go to Vimeo.com and sign up for a free account. Then navigate to the Video's page and in the lower right area of the page is a Downloand Video link. Right click on this and use Save Target As...
Posted by: Mark Flayler | 01/30/2010 at 09:22 AM
Great video Mark. I have a question.
You show the 'Edit Factory Scope' & 'Edit Member Scope' buttons within the Styles and Standards ribbon. How can I accomplish this?
Thanks in advance.
Bob
Posted by: bstewart@gyptech.on.ca | 01/31/2010 at 10:10 AM
Bob, you have to use the Customize User Commands and actually add them as a separate Panel right next to the place they should go. It was an oversight in 2010 and I was told at AU that it is to be fixed in 2011.
Posted by: Mark Flayler | 03/23/2010 at 03:12 PM