Inventor Add-in: Center Point Rectangle - IMAGINiT Manufacturing Solutions Blog

« AutoCAD Shortcut List | Main | Inventor Factory Command Reference »

12/13/2010

Comments

Feed You can follow this conversation by subscribing to the comment feed for this post.

Thanks a lot! So usefull!
I was looking for that tool since I started using inventor.

But the link gives you only the readme.
You must follow the link shown on youtube:
- Forum (feedback): http://www.mcadforums.com/forums/viewtopic.php?f=34&t=11365.

- Link to installer: http://www.mcadforums.com/forums/download/file.php?id=3369&sid=8889077ede7cf52926228a8ec99be7e5 (don't know if it works right here or you must go first to the forum)

Again, thank you!

Thanks for catching the oversight Fmateo, I updated the link to include the installer. For the most current version it is always a good idea to check MCAD forums as well though.

Hi,

Thanks a lot! Maybe you also have seen somhere add-in with center point rectangular slot? or other slots?
In a way it is the same center pont rectangular, just fillets added, it would same some extra time as well ;)
Thanks!

The comments to this entry are closed.