By John Carlson
Watch this short video (less than 5 minutes!) on how to create a separate layer tree and detach the model tree in Creo Parametric.
« CATIA V5 Tip: How to control the length of a curve in a sketch | Main | Creo Parametric 3.0 Tip - How to Create a Conditional Drawing Note »
11/01/2017
Customizing the Navigator Panel
Posted by Rand 3D on 11/01/2017 at 09:45 AM in Creo, Tips and Tricks | Permalink
| | |
|
The comments to this entry are closed.
 |
 |
 |
 |
Recent Posts
- Doing Splits the easy way: Splitting Surfaces in CATIA V5
- CATIA V5 Tip: Sketcher Outputs
- CATIA V5 Tip: Adding Balloon Callouts to an Assembly Drawing
- Creating a Manikin Simulation in CATIA V5
- Creo Parametric Tip: A Design Consideration When Creating a Flat Pattern for a Complex Harness
- Creo Parametric: An Overview of the Electromechanical Cabling Design Process
- Exporting 3D Annotations from CATIA to STEP
- CATIA V5 Tip: Adding an offset to a Manikin Segment
- Executing a Manikin Hand Grasp in CATIA V5
Comments