If you are trying to export a 3d view to Navisworks as an .nwc file and you are getting the following error "No suitable geometry found....
In my testing I was able to get rid of this error and export the file successfully if I removed any assigned view template and set it to none as shown below.
This will allow us to make changes to the Visibility Graphics settings.
On the Model tab, select Detail Items category and take the checkmark out.
You should now be able to export the file.
The issue is within the family. In the 3d view, check your 'Annotation Categories' and make sure the 'Show annotation categories in the view' is not checked.
My export worked fine after tracking this down. BTW, this issue was in the consultants electrical link.
Posted by: Charles Karl | 10/25/2015 at 04:07 PM
Charles is also correct...the issue can come from a link as well.
Posted by: Sherry | 10/29/2015 at 03:20 PM