Revit Structure Settings for Boundary Conditions

If you started a project without using the Structural Template you will need to do two things to manually set the boundary condition settings in your project so that you can place the Boundary Condition elements.

Process

• Load all of the Boundary Condition families from the Boundary Conditions folder in either the imperial or metric library
• On the Structure tab, Structure panel, select the arrow in the lower right corner of the panel to open the Structural Settings dialog box.

• Go to the Boundary Conditions tab and set the symbols as shown below.

Comments

[Ali]

Thanks alot Sherry I seek through internet for this solution, finally I find it here. I am working on my thesis on BIM topic and I obtained this annoying error !

Thanks again for your article !

Regards;
Ali